Time Left - 06:00 mins

SSC JE CE 2017- RCC & Steel Design Ranker Quiz 3

Attempt now to get your rank among 2510 students!

Question 1

Which of the following assumptions are made in the design of rivet joints?
A) Rivets are stressed equally
B) Stress in plate is maximum at mid-width
C) Rivet hole is completely filled by rivet
D) Friction between plates is neglected

Question 2

The strength of fillet weld is _____.

Question 3

Design of a riveted joint assumes that _____.

Question 4

If P is the wind pressure in kg/cm², v is the velocity in km/hour and K is constant of proportionality then _____.

Question 5

Fillet weld is not recommended if the angle between fusion faces is ______.
A) Less than 45^o
B) Greater than 120^o
C) less than 60^o
D) Greater than 145^o
The correct statements are

Question 6

If 18 mm rivets are used in lacing bars, then minimum width of lacing bars should be

Question 7

Splice covers and its connection in a tension member should be designed

Question 8

The common assumption that all rivets share equally non-eccentric load is valid at a load _____.

Question 9

The buckling load in a steel column is _______.

Question 10

For unstiffened flange of a beam in flexural compression, the maximum allowable outstand is equal to ______.

2510 attempts
9 upvotes
25 comments

Tags :

ESE & GATE CE Design of Concrete Structures Design of Steel Structures

Jul 9ESE & GATE CE