Time Left - 10:00 mins
ESE ME: Strength of Materials Champion Quiz 2
Attempt now to get your rank among 948 students!
Question 1
What is the value of bending stress for a bar of diameter 75 mm for moment of 6.75×103 Nm ?
Question 2
The transverse shear stress acting in a beam of rectangular cross-section, subjected to a transverse shear load, is
Question 3
The point of contra flexure is a point where:
Question 4
What is the shape of the transverse shear stress distribution across a rectangular cross-section beam?
Question 5
Statement (I): If the bending moment along the length of a beam is constant, then the beam cross-section will not experience any shear stress.
Statement (II): The shear force acting on the beam will be zero everywhere along its length.
Statement (II): The shear force acting on the beam will be zero everywhere along its length.
Question 6
A uniformly distributed load W (in kN/m) is acting over the entire length of a 3 m long cantilever beam. If the shear force at the mid-point of cantilever is 6 kN, what is the value of W?
Question 7
A T-section beam is simply supported and subjected to a uniformity load over its whole span. Maximum longitudinal stress in the beam occurs at
Question 8
Assertion (A): Tensile strength of CI is much higher than that of MS.
Reason (R): percentage of carbon CI is more than 1.5.
Reason (R): percentage of carbon CI is more than 1.5.
Question 9
The total area under the stress-strain curve of a mild steel specimen tested up to failure under tension is a measure of
Question 10
Bars AB and BC, each of negligible mass, support load P as shown in the figure. In this arrangement,
- 948 attempts
- 4 upvotes
- 42 comments
May 6ESE & GATE ME
