Time Left - 10:00 mins
ESE ME: Strength of Materials Champion Quiz 4
Attempt now to get your rank among 754 students!
Question 1
Where does the maximum hoop stress in a thick cylinder under external pressure occur?
Question 2
Consider the following statement for a pressure vessel which is subjected to internal pressure:
1). Radial stress at inner radius is always zero.
2). Radial stress at outer radius is always zero.
3). The tangential stress is always higher than other stresses.
4). The tangential stress is always lower than other stresses.
Which of these statement are correct?
1). Radial stress at inner radius is always zero.
2). Radial stress at outer radius is always zero.
3). The tangential stress is always higher than other stresses.
4). The tangential stress is always lower than other stresses.
Which of these statement are correct?
Question 3
A water main of 1 m diameter contains water at a pressure head of 100 meters. The permissible tensile stress in the material of the water main is 25 MPa. What is the minimum thickness of the water main? (Take g = 10 m/s2)
Question 4
An Aluminium beam column having length of 10 m with Moment of Inertia 950cm4 is fixed from both ends. The Modulus of Elasticity of Aluminium is 80×109 Pa . Calculate Euler buckling load?
Question 5
Match List-I (long column) with List-II (critical load) and select the correct answer using the code given below the lists:
List-I
A). Both ends hinged
B). One end fixed and other end free
C). Both ends fixed
D). One end fixed and other end hinged
List–II
1).
2).
3).
4).
List-I
A). Both ends hinged
B). One end fixed and other end free
C). Both ends fixed
D). One end fixed and other end hinged
List–II
1).
2).
3).
4).
Question 6
If diameter of a long column is reduced by 20%, the percentage reduction in Euler’s buckling load for the same end conditions is
Question 7
A thin gas cylinder with an internal radius of 100 mm is subject to an internal pressure of 10 MPa. The maximum permissible working stress is restricted to 100 MPa. The minimum cylinder wall thickness (in mm) for safe design must be
Question 8
A structural member subjected to an axial compressive is called
Question 9
Match List-1 (Cantilever loading) with List-II (shear Force Diagram) and select the correct answer using the coded given below the lists:
Lists-I
List-II
Lists-I
List-II
Question 10
A shaft subjected to combined twisting moment T and bending moment M. What is the equivalent bending moment?
- 754 attempts
- 3 upvotes
- 48 comments
Sep 15ESE & GATE ME