Time Left - 20:00 mins
GATE CE: Solid Mechanics Champion Quiz 3
Attempt now to get your rank among 555 students!
Question 1
The total area under the stress-strain curve of a mild steel specimen tested up to failure under tension is a measure of
Question 2
In a bi-axial stress problem, the stresses in x and y directions are and The maximum principal stress in MPa is
Question 3
The maximum and minimum shear stresses in a hollow circular shaft of outer diameter 20mm and thickness 2mm. Subjected to a torque of 92.7 N.m will be
Question 4
What is the maximum torque transmitted by a hollow shaft of external radius R and internal radius r?
( where fs is shear stress of material)
( where fs is shear stress of material)
Question 5
A 40 mm diameter shaft is subjected to a twisting moment Mt. If shear stress developed in shaft is 5 N/mm2, what is the value of the twisting moment?
Question 6
A torque T is applied at the free end of a stepped rod of circular cross-sections as shown in the figure. The shear modulus of the material of the rod is G. The expression for d to produce an angular twist at the free end is
Question 7
The diameter of a solid shaft is D. the inside and outside diameters of a hollow shaft of same material and length are and respectively. What is the ration of the weight of the hollow shaft to the solid shaft?
Question 8
In a plane stress condition, the components of stress at a point are σx= 20 MPa, σy = 80 MPa and τxy = 40 MPa the maximum shear stress (in MPa) at the point is
Question 9
If E = elasticity modulus, I = moment of inertia about the neutral axis and M = bending moment in pure bending under the symmetric loading of a beam, the radius of curvature of the beam:
1). Increases with E
2). Increases with M
3). Decreases with I
4). Decreases with M
Which of these are correct ___________?
1). Increases with E
2). Increases with M
3). Decreases with I
4). Decreases with M
Which of these are correct ___________?
Question 10
A solid circular shaft of diameter 100 mm is subjected to an axial stress of 50 MPa. It is further subjected to a torque of 10 kNm. The maximum principal stress experienced on the shaft is closest to
- 555 attempts
- 0 upvotes
- 25 comments
Jul 8ESE & GATE CE