Time Left - 10:00 mins

ESE CE: Solid Mechanics Champion Quiz 3

Attempt now to get your rank among 630 students!

Question 1

What is the bending moment at A for the bent column shown in the figure given below?

Question 2

Couple M is applied at C on a simply supported beam AB. What is the maximum shear force for the beam?

Question 3

Shear span is defined as the zone where

Question 4

The major and minor principal stresses at a point are 3 MPa and –3 MPa respectively. The maximum shear stress at that plane is

Question 5

For the component loaded with a force F as shown in the figure, the axial stress at the corner point P is

Question 6

The bending equation is written as

Question 7

E, G, K, and μ represent the elastic modulus, shear modulus, bulk modulus and Poisson’s ratio respectively of a linearly elastic, isotropic and homogeneous material. To express the stress–strain relation completely for this material, at least

Question 8

The magnitude of shear induced in a shaft due to applied torque varies

Question 9

A solid circular shaft of 60 mm diameter transmits a torque of 1600 N.m. The value of maximum shear stress developed is

Question 10

The Principal stresses at a point in two–dimensional stress system are σ₁ and σ₂ and corresponding principal strain are ∈₁ and ∈₂. If E and μ denote Young’s modulus and Poisson’s ratio, respectively, then which one of the following is correct?

630 attempts
5 upvotes
43 comments

Tags :

ESE & GATE CE Strength of Materials

Jul 27ESE & GATE CE