Time Left - 20:00 mins
GATE ME: Engineering Materials Champion Quiz 2
Attempt now to get your rank among 1941 students!
Question 1
If stress values is measured during the tensile test, then which of the following have higher actual value than initial value?
Question 2
Addition of copper to aluminium results in __________.
Question 3
Stress-strain curves are an important graphical measure of material’s mechanical properties. It is seen that strain energy increases quadratically with the stress or strain; i.e. that as the strain increases the energy stored by a given increment of additional strain grows as the square of the strain.
In the Stress Strain Curve as shown, point U is known as:
Question 4
Hook’s law of proportionality in the diagram can be explained between point:
Question 5
Which types of stress strain relationship best describes the behaviour of brittle materials as ceramics and thermosetting plastics?
Question 6
Elasticity of various materials is controlled by its
Question 7
If a particular Fe–C alloy contains less than 0.83% carbon, it is called
Question 8
A steel bar of 40 mm × 40 mm square cross-section is subjected to an axial compressive load of 200 kN. If the length of the bar is 2m and E = 200 GPa, the elongation of the bar will be:
Question 9
Which of the following has maximum hardness
Question 10
Engineering strain of a mild steel sample is recorded as 0.100%. The true strain is _________.
- 1941 attempts
- 7 upvotes
- 120 comments
Feb 5ESE & GATE ME