Time Left - 10:00 mins
ESE EC : Measurements & Instrumentation Champion Quiz 1
Attempt now to get your rank among 705 students!
Question 1
Which of the following bridges is also used in an oscillator?
Question 2
Kelvin’s double bridge is used for measurement of
Question 3
Hay bridge is suitable for measuring inductance of which one of the following inductors?
Question 4
The bridged-T network circuit shown above can be used for determination of inductance and Q of R.F. coils. Lz and Rx are unknown parameters of the coil. Using equations for balance, what are the values of Lz and Rx?
Question 5
A Q-meter is supplied with an oscillator having a 500 mV output voltage. While testing an unknown inductor, the voltage across the variable capacitor of the Q-meter, measured by a digital voltmeter, is obtained as 10 V. The Q-factor of the inductor is
Question 6
Error cause by the act of measurement on the physical system being tested is
Question 7
A current of 2 ± 0.5% A passes through a resistor of 100 ± 0.2% Ω. The limiting error in the computation of power will be
Question 8
The accuracy of a 0-10 mA meter is ±2%. What is its accuracy while taking a reading of 5 mA?
Question 9
The expected value of the voltage across a resistor is 80 V. However, the voltmeter reads 79 V. The absolute error in the measurement is
Question 10
Which one of the following meters has maximum loading effect on the circuit under measurement?
- 705 attempts
- 3 upvotes
- 34 comments
May 17ESE & GATE EC