Time Left - 10:00 mins
ESE EE : Analog Electronics Champion Quiz 5
Attempt now to get your rank among 623 students!
Question 1
Which one of the following circuits is used for converting a sine wave into a square wave?
Question 2
Pulses of definite width can be obtained from irregular shaped pulses:
Question 3
Statement(I): A monostable multi-vibrator when swiched on remains in a quasi stable state .
Statement (II): Quasi stable state duration is decided by charging time of capacitor
Statement (II): Quasi stable state duration is decided by charging time of capacitor
Question 4
In the order to obtain repetitive pulses of unequal mark space one can use:
1) A voltage comparator fed with a triangular wave signal and dc voltage.
2) An astable multi-vibrator
3) A mono-stable multi-vibrator fed with a square wave input
1) A voltage comparator fed with a triangular wave signal and dc voltage.
2) An astable multi-vibrator
3) A mono-stable multi-vibrator fed with a square wave input
Question 5
The circuit shown below is a
Question 6
A 1μs pulses can be converted into a 1ms by using
Question 7
Assertion(A): It is possible to use the technique of additive amplification to get a wide band amplifier.
Reason (R): In additive amplifier the overall gain of the amplifier is the sum of the gain of the individual amplifiers.
Reason (R): In additive amplifier the overall gain of the amplifier is the sum of the gain of the individual amplifiers.
Question 8
When two identical stages with upper cut-off frequency ωH are cascaded, overall cut-off frequency is at.
Question 9
The peak output of a tuned amplifier is at 6 MHz and has quality factor of 60. The bandwidth and 3 dB frequencies shall be.
Question 10
A tuned amplifier has a maximum output at 4 MHz with a quality factor 50. The bandwidth and half power frequencies are, respectively.
- 623 attempts
- 2 upvotes
- 8 comments
Feb 5ESE & GATE EE