Time Left - 15:00 mins
ISRO EC Quiz 2 : Networks
Attempt now to get your rank among 1285 students!
Question 1
Which two-port parameters are best suited for analyzing a series-shunt feedback circuit?
Question 2
The Q =1, of RLC tuned circuit with source voltage V in the figure is 100 at resonant frequency of 100 KHz. What is the voltage VL across inductor at resonance?
Question 3
The circuit is with an ideal operational amplifier with V supply. The output voltage is :
Question 4
A step voltage of 1 V applies to the circuit at t = 0. The current through the resistor R just after t = 0 and at steady state are :
Question 5
In the circuit shown below, switch and are in open and close position respectively for long time. At t = , switch is closed and switch is opened. What would be the current through immediately after the transition of switches?
Question 6
In the circuit shown below, if the source voltage then the Thevenin’s equivalent voltage in Volts as seen by the load resistance RL is
Question 7
Two magnetically uncoupled inductive coils have Q factors q1 and q2 at the chosen operating frequency. Their respective resistances are R1 and R2. When connected in series, their effective Q factor at the same operating frequency is
Question 8
For the R-L circuit shown in Figure, the input voltage v i(t) = u(t). The current i(t) is
Question 9
Consider the network graph shown in figure. Which one of the following is NOT a ‘tree’ of this graph?
Question 10
In the circuit shown the average value of the voltage Vab (in Volts) in steady state condition is ______
- 1285 attempts
- 11 upvotes
- 34 comments
Nov 24ESE & GATE EC