Time Left - 05:00 mins
SSC JE Mechanical 2017- Daily Quiz 7
Attempt now to get your rank among 1884 students!
Question 1
What is the value of pressure angle generally?
Question 2
A tool with side cutting edge angle of and end cutting edge of is used for fine turning with a feed of 1 mm/rev, neglecting nose radius of the tool. The peak height of surface roughness produced will be.
Question 3
The polar section modulus of a circular section about an axis through its centre of gravity is ________.
Question 4
Two springs having spring constant k and k in the arrangement as shown in figure.Equivalent spring Constant keq is
Question 5
The index of expansion of dry saturated steam flowing through a nozzle is equal to 1.135, and then what is the critical pressure ratio for this flowing steam in the nozzle?
- 1884 attempts
- 6 upvotes
- 27 comments
Tags :
ESE & GATE MEGeneralMay 10ESE & GATE ME