Time Left - 10:00 mins
ESE ME 2018 Exam: Practice Quiz 1
Attempt now to get your rank among 1595 students!
Question 1
The ordinates and abscissae of the diagram given for the vapour-compression refrigeration cycle represent
Question 2
Match List-I (Component) with List-II (Required Property) and select the correct answer using the codes given below the lists:
List-I
[A]. Blades of bulldozer
[B]. Gas turbine blades
[C]. Drill bit
[D]. Spring of automobiles
List-II
[1]. High wear resistance and high toughness
[2]. Low Young’s modulus and high fatigue strength
[3]. High wear and abrasion resistance
[4]. High creep strength and good corrosion resistance
List-I
[A]. Blades of bulldozer
[B]. Gas turbine blades
[C]. Drill bit
[D]. Spring of automobiles
List-II
[1]. High wear resistance and high toughness
[2]. Low Young’s modulus and high fatigue strength
[3]. High wear and abrasion resistance
[4]. High creep strength and good corrosion resistance
Question 3
The preferred type of pump for small discharge and high head is
Question 4
A refrigerated van has to be maintained at -100 C, while ambient temperature is 320 C. Overall surface area of the van is 25 m2. The walls of the van are of 16 mm plywood (k = 0.06 W/mK) at inner surface and 12 mm of glass work (k= 0.06 W/mK). The capacity of the refrigerated van in tons of refrigeration will be
Question 5
Which one of following is a continuous bending process in which opposing rolls are used to produce long sections of formed shapes from coil or strip stock?
Question 6
Which one of the following is correct?
In the basic ECQ model, if lead time increases from 5 to 10 days, the EOQ will
In the basic ECQ model, if lead time increases from 5 to 10 days, the EOQ will
Question 7
Which one of the following statements relating to belt driver is correct __________?
Question 8
A piece of material is subjected to two perpendicular tensile stresses of 70 MPa and 10MPa .The magnitude of the resultant stress on a plane in which the maximum shear stress occurs is
Question 9
The controlling force curves for a spring- controlled governor are shown in the above figure. Which curve represents a stable governor
Question 10
Consider the following statements:
1). The actual entry point through which the molten metal enters the mould cavity is called ingate.
2). Bottom gate in case of a mould creates favourable temperature gradient.
3). Sprue in case of a mould is made tapered to avoid air inclusion.
Which of the statements is/are correct?
1). The actual entry point through which the molten metal enters the mould cavity is called ingate.
2). Bottom gate in case of a mould creates favourable temperature gradient.
3). Sprue in case of a mould is made tapered to avoid air inclusion.
Which of the statements is/are correct?
- 1595 attempts
- 3 upvotes
- 23 comments
Tags :
ESE & GATE MEGeneralOct 27ESE & GATE ME