Time Left - 20:00 mins
ISRO Mechanical Exam 2017: Weekly Toppers Quiz 3
Attempt now to get your rank among 670 students!
Question 1
In a certain ideal refrigeration cycle, the COP of the refrigerator is 3. The cycle under ideal conditions running as heat engine will have efficiency equals to
Question 2
A copper bar of 25 cm length is fixed by means of supports at its ends. Supports can yield (total) by 0.01 cm. If the temperature of the bar is raised by 100 °C, then the stress induced in the bar for if αc = 20×10-6/°C and Ec = 0.5×105 MPa will be
Question 3
Find the differential equation whose solution represents the family .
Question 4
In a single degree damped vibrating system, the logarithmic decrement is 0.278. Mass of the vibrating body is 10 kg and spring stiffness is 1000 N/m. The damping constant in N/m/s is________.
Question 5
In orthogonal cutting the depth of cut is 0.5 mm at a cutting speed of 3 m/s. If the chip thickness is 0.75 mm, the Chip velocity is _____.
Question 6
Consider the following system of equations:
2x1 + x2 + x3 = 0,
x2 - x3 = 0,
x1 + x2 = 0.
This system has
2x1 + x2 + x3 = 0,
x2 - x3 = 0,
x1 + x2 = 0.
This system has
Question 7
Large speed reductions (greater than 20) in one stage of a gear train are possible through
Question 8
In order to have interfernce fit, it is essential that the lower limit of the shaft should be
Question 9
When t01 and t02 are the temperature of cold fluid at entry and exit respectively and are the temperature of hot fluid at entry and exit point, and cold fluid has lower heat capacity rate as compared to hot fluid then effectiveness of the heat exchanger is given by
Question 10
It is observed that a bus is moving with a speed of 90km/hr loses it brakes. If the driver happens to carry the bus into the runaway hill, then how will the vehicle travel before it comes to a stop?
Question 11
The case hardening of gear components of machine tools is done by
Question 12
Assuming i = √-1 and t is a real number, is;
Question 13
The determinant of the given matrix is _________.
Question 14
For the configuration shown, the minimum head H in the vessel will be
[Take Cv=1]
[Take Cv=1]
Question 15
A weight of 500 N is supported by two metallic ropes as shown in the figure. The values of tensions T1 and T2 are respectively
- 670 attempts
- 4 upvotes
- 11 comments
Tags :
ESE & GATE MEGeneralFeb 4ESE & GATE ME