Time Left - 10:00 mins
ESE ME 2018 Achiever Study Plan:Strength of Materials Quiz 3
Attempt now to get your rank among 571 students!
Question 1
A cantilever beam, 2m in length, is subjected to a uniformly distributed load of 5 N/m. If E = 200GPa and I = 1000 cm4, the strain energy stored in the beam will be
Question 2
A seamless pipe of diameter d m is to carry fluid under a pressure of p kN/cm2. The necessary thickness t of metal in cm, if the maximum stress is not to exceed σ kN/cm2 is
Question 3
Maximum deflection in cantilever due to pure bending moment M at its end is ________.
Question 4
Couple M is applied at C on a simply supported beam AB. The maximum shear on AC will be
Question 5
A thin cylinder contains fluid at a pressure of 30 kg/cm2 . The inside diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have minimum wall thickness of
Question 6
A thin walled spherical shell is subjected to an internal pressure. If the radius of the shell is increased by 1% and the thickness is reduced by 1%, with the internal pressure remaining the same, the percentage change in the circumferential (hoop) stress is
Question 7
A thin layer of 4 m inner diameter has a wall thickness of 50 mm. It is subjected to an internal pressure of 2 MPa. What is the maximum shear stress induced in an element considered on the inner surface?
Question 8
A simply supported laterally loaded beam was found to deflect more than a specified value. Which of the following measures will reduce the deflection?
Question 9
A beam of length L is carrying a uniformly distributed load w per unit length. The flexural rigidity of the beams is EI. The reaction at the simple support at the right end is
Question 10
The strain energy stored in the beam with flexural rigidity EI and loaded as shown in the figure is
- 571 attempts
- 0 upvotes
- 6 comments
Jun 7ESE & GATE ME
