Time Left - 10:00 mins
Subject Revision:Analog Communication Quiz
Attempt now to get your rank among 1070 students!
Question 1
Weak components of a signal with non-flat psd can be protected against channel noise and frequency dependent channel response by a pair of spectral operations. These components can be amplified before transmission and attenuated after reception leading to both flat end-to-end channel response and higher SNR. What are the names of these operations
Question 2
What would be the bandwidth of the output signal of SSB-AM (USB) modulator illustrated below when the bandwidth of the baseband message signal is 3 kHz and c(t) = 2sin(200 * 103 πt).
Question 3
A device with input x(t) and output y(t) is characterized by: y(t) = x2(t). An FM signal with frequency deviation of 90 kHz and modulating signal bandwidth of 5 kHz is applied to this device. The bandwidth of the output signal is
Question 4
The AM signal gets added to a noise with Power Spectral Density Sn(f) given in the figure below. The ratio of average sideband power to mean noise power would be:
Question 5
The signal m(t) as shown is applied both to a phase modulator (with kp as the phase constant) and a frequency modulator (with kf as the frequency constant) having the same earner frequency.
The ratio kp/kf (in rad/Hz) for the same maximum phase deviation is
The ratio kp/kf (in rad/Hz) for the same maximum phase deviation is
- 1070 attempts
- 5 upvotes
- 12 comments
Jun 7ESE & GATE EC