Time Left - 15:00 mins
BARC ME Live Quiz Session Solution (@ 7th March)
Attempt now to get your rank among 1156 students!
Question 1
The flow rate of fluid flowing through a conduit is to be measured for analysis. The flow rate depends mainly on hydraulic properties of conduit like;
Question 2
The state of 2D–stress at a point is given by the following matrix of stress:
What is the magnitude of maximum shear stress(Radius of Mohr's circle) in MPa?
Question 3
For laminar flow over a flat plate, the thickness of the boundary layer at a distance from the leading edge is found to be 5 mm. The thickness of the boundary layer at a downstream section, which is at twice the distance of the previous section from the leading edge, will be
Question 4
A clutch is to be designed for a machine. The operating loads are heavy, thus proper friction material is to be selected. The material is used as disc-friction facing for the clutch is;
Question 5
The minimum number of links in a constrained planer mechanism involving revolute pairs and two higher pairs is _________.
Question 6
A 1 kg block is resting on a surface with Coefficient of friction μ = 0.1 A force of 0.8 N is applied to the block as shown in the figure. The friction force is
Question 7
Addition of magnesium to cast iron increases its ____________.
Question 8
Match List-I with List-II and select the correct answer using the codes given below the lists:
Question 9
Consider a simply supported beam of length 50h, with a rectangular cross-section of depth ‘h’ and width ‘2h’. The beam carries a uniformly distributed load of the intensity of w per metre. The ratio of the maximum bending stress to the maximum shear stress anywhere in the beam is ____.
Question 10
If the speed of an engine varies between 390 and 410 rpm in a cycle of operation, the coefficient of fluctuations of speed would be:
- 1156 attempts
- 2 upvotes
- 25 comments
Tags :
ESE & GATE MEGeneralApr 14ESE & GATE ME