Time Left - 08:00 mins
DMRC 2018 Civil Engineering Quiz 2
Attempt now to get your rank among 951 students!
Question 1
In the consolidated undrained triaxial test on a saturated soil sample, the pore water pressure is zero
Question 2
The state of 2D–stress at a point is given by the following matrix of stress:
What is the magnitude of maximum shear stress(Radius of Mohr's circle) in MPa?
Question 3
The ratio of vertical reactions at support A and B of the simply supported beam in the figure shown below is .
Question 4
A Bench Mark (BM) with Reduced Level (RL) = 155.305 m has been established at the floor of a room. It is required to find out the RL of the underside of the roof (R) of the room using Spirit Leveling. The Back Sight (BS) to the BM has been observed as 1.500 m whereas the Fore Sight (FS) to R has been observed as 0.575 m (Staff held inverted). The RL (m) of R will be
Question 5
Name the traffic survey data which is plotted by means of “Desire lines”.
Question 6
A rectangular timber beam is cut out of a cylindrical log of diameter 'ID'. The depth of the strongest timber beam will be
Question 7
The flexural strength of M 30 concrete as per IS: 456-2000 is
Question 8
In a homogenous, isotropic and elastic material, the modulus of elasticity E in terms of G and K is equal to
Question 9
Group I lists a few devices while Group II provides information about their uses. Match the devices with their corresponding use.
Question 10
The maximum shear stress in a rectangular beam is_____ times of average shear stress
- 951 attempts
- 5 upvotes
- 28 comments
Tags :
ESE & GATE CEGeneralOct 13ESE & GATE CE