Time Left - 08:00 mins
DMRC 2018 Electrical Engineering : Quiz 15
Attempt now to get your rank among 818 students!
Question 1
What is the ratio of the average output voltage to per phase maximum AC voltage in a three-phase half-wave diode rectifier on a resistive load?
Question 2
What is the plug setting multiplier if The pickup value of relay is 6.5 Amp and fault current in relay coil is 39 Amp?
Question 3
In a 4 – pole, 3 – phase, 50Hz induction motor running at 1425 rpm. The frequency of rotor current of motor is –
Question 4
Class………………power amplifier has the highest power efficiency.
Question 5
Two small spheres, each carrying a charge Q, placed d metres apart repel each other with a force F. If one of the spheres is taken around the other one in a circular path of radius r, the work done will be
Question 6
What is the length of paper used in a capacitor of capacitance if the dielectric constant of the paper is 2.5 and its width and thickness are 50 mm and 0.05 mm respectively?
Question 7
In the given question, what is the shorted terminal current in the equivalent current source?
Question 8
The current drawn by a tungsten filament lamp is measured by an ammeter. The ammeter reading under steady state condition will be ____________ the ammeter reading when the supply is switched on.
Question 9
The steady state error of a unity feedback control system having open loop transfer function K/[s(s+2)] due to step input is:
Question 10
Consider the Mod-3 counter as below:
If two J-K F/Fs are used to realize this counter, what will be the values of J0, K0, J1, K1?
If two J-K F/Fs are used to realize this counter, what will be the values of J0, K0, J1, K1?
- 818 attempts
- 6 upvotes
- 11 comments
Tags :
ESE & GATE EEGeneralAug 18ESE & GATE EE