Time Left - 05:00 mins
Mechanical SSC J.E Quiz-44
Attempt now to get your rank among 1418 students!
Question 1
The shoulder provided on the shaft using antifriction bearings is to prevent:
Question 2
When can a piezometer be not used for pressure measurement in pipes?
Question 3
In an experiment, positive and negative values are equally likely to occur. The probability of obtaining at most one negative value in five trials is
Question 4
Which one of the following is the major alloying element in Invar?
Question 5
In a steam condenser the partial pressure of Steam and Air are 0.06 bar and 0.007 bar respectively, the condenser pressure is.
Question 6
Which one of the following is correct, when a nut is tightened by placing a washer below it, the bolt will be subjected to _________.
Question 7
In the selection of optional cutting conditions, the requirement of surface finish would put a limit on which of the following?
- 1418 attempts
- 1 upvote
- 9 comments
Tags :
ESE & GATE MEGeneralMay 21ESE & GATE ME