Time Left - 12:00 mins

ESE Technical Revision Quiz 3

Attempt now to get your rank among 301 students!

Question 1

Statement (I): The bias stability of a self bias amplifier circuit cab be improved by increasing the values of both the base resistor (R_B) and the emitter resistor (R_E)
Statement (II): The base resistor (R_B) provides the required voltage to the base terminal and the emitter resistor (R_E) provides negative feedback to the amplifier.

Question 2

In an 8-bit D/A converter, the reference voltage used is 10V. What voltage is
represented by 1010 0001?

Question 3

With reference to C programming language, which of the following statements are correct?
1). An identifier may start with an underscore.
2). An identifier may end with an underscore.
3). IF is a valid identifier.
4). The number of significant characters in an identifier is implementation dependent.
Select the correct answer from the codes given below:

Question 4

The duration of the transient period in a control system is referred to as:

Question 5

The product of which of the following gives the figure of merit of a logic family?

Question 6

Which among the following Maxwell Equation represents Gauss law of Electricity?

Question 7

In integrated circuits, the design of electronic circuits is based on the approach of use of

Question 8

Which instrument is used to control the frequency of the output signal?

Question 9

A transmission line has characteristic impedance of 500 Ω. It has been terminated in a 200 Ω load. If the load is dissipating a continuous power of 100Ω, its reflection coefficient is.

Question 10

If the three resistors in a delta network are all equal in values i.e. R_DELTA, then the value of the resultant resistors in each branch of the equivalent star network i.e. R_STAR will be equal to:
(R_D→R_DELTA ; _Rs→R_STAR)

301 attempts
1 upvote
4 comments

Tags :

ESE & GATE EC General

May 20ESE & GATE EC