Time Left - 12:00 mins
ESE Technical Revision Quiz 17
Attempt now to get your rank among 287 students!
Question 1
If an input sequence x(t)=p(t) of an LTI system having an impulse response is z(t) = atp(t), |n|<1, then find the output signal q(t) of the system.
Question 2
What will be the total modulation index if a wave is amplitude modulated by three sine waves with modulation indices of 25%, 50% and 75%?
Question 3
Which one of the following is correct fro ASCII codes of all upper case English letters compared to all lower case English letters?
Question 4
Bandwidth as described in amplitude ratio graph shown for T and set-point response is:
Question 5
A half adder can be constructed using
Question 6
If the length of dipole antenna is close to 1 wavelength, then:
Question 7
Match List-I (Type of Conductor) with List-II (Position of Fermi Level) and select the correct answer using the codes given below the lists:
List-I
A) n-type semiconductor
B) p-type semiconductor
C) Intrinsic semiconductor
D) Degenerate n-type semiconductor
List-II
1) Middle of band gap
2) Above conduction band
3) Near but below conduction band
4) Near but above valence band
List-I
A) n-type semiconductor
B) p-type semiconductor
C) Intrinsic semiconductor
D) Degenerate n-type semiconductor
List-II
1) Middle of band gap
2) Above conduction band
3) Near but below conduction band
4) Near but above valence band
Question 8
A ray of light incident on a glass slab (of refractive index 1.5) with an angle, then the value of sine of angle of refraction is:
Question 9
A current of 2.0 A passes through a cell of emf 1.5 V having internal resistance of 0.15 Ω. The potential difference across the terminals of the cell is
Question 10
What are the ABCD parameters of the single element circuit given below?
- 287 attempts
- 4 upvotes
- 5 comments
Tags :
ESE & GATE ECGeneralDec 17ESE & GATE EC