Time Left - 15:00 mins
ESE 2019: Technical Mini Mock Quiz-5
Attempt now to get your rank among 1846 students!
Question 1
Which of the following elements given below determine(s) the maximum attainable, hardness in steel?
[1]. Chromium
[2]. Manganese
[3]. Carbon
[4]. Molybdenum
Select the correct answer using the code given below?
[1]. Chromium
[2]. Manganese
[3]. Carbon
[4]. Molybdenum
Select the correct answer using the code given below?
Question 2
Uniform heat generation takes place in a symmetric slab so that heat flows towards both sides in contact with fluid. The zero-grsdient boundary condition occurs at
Question 3
|
Question 4
A machine component is subjected to a flexural stress, which fluctuates between 300 MN/m2 and –150 MN/m2. Taking the yield strength = 0.55 of the ultimate strength, endurance strength = 0.50 of the ultimate strength and factor of safety to be 2, the value of the minimum ultimate strength according to Goodman relation will be
Question 5
Assertion (A): The plastic organic material can be easily shaped or moulded by mechanical action.
Reason (R):It is widely in use as it can be permanently moulded.
Reason (R):It is widely in use as it can be permanently moulded.
Question 6
Direction: The following items consists of two statements; one labelled as ‘Assertion (A)’ and the other as ‘Reason (R)’. You are to examine these two statements carefully and select the answers to these items using the codes given below:
Assertion (A): Most of the materials exist in single crystal.
Reason (R): Sugar is a single crystal material.
Reason (R): Sugar is a single crystal material.
Question 7
The propeller of an aircraft fitted with electric motor operates at 1400 rpm. What will be its angular speed in radians/second?
Question 8
From the performance characteristic curve of centrifugal pump, which information is correct?
i) efficiency of pump should be maximum 65%
ii) discharge of pump to take place around 16 lps
iii) operating head discharge should be maximum 35m
i) efficiency of pump should be maximum 65%
ii) discharge of pump to take place around 16 lps
iii) operating head discharge should be maximum 35m
Question 9
If two similar dimensional parallel plates are welded using butt welding with electric arc, then on change of plate thickness, the welding will now be done by
Question 10
The final coordinates in xyz axes on changing rotation order when u is rotated by -90o about +z and -90 about +y, if u being [0 1 0].
Question 11
The commercially available biomass fuel is not:
Question 12
Nuclear energy is not preferred over wind energy because of presence of:
i. wind mills
ii. nuclear radiation
iii. nuclear waste
i. wind mills
ii. nuclear radiation
iii. nuclear waste
Question 13
The state of stress at a point when completely specified enables one to determine the
1) maximum shearing stress at the point
2) stress components on any arbitrary plane containing that point
Which of the above is/are correct?
1) maximum shearing stress at the point
2) stress components on any arbitrary plane containing that point
Which of the above is/are correct?
Question 14
If primary direct crank of reciprocating engine makes θ with line of stroke, then what angle will the secondary direct crank makes with the line of stroke?
Question 15
A: All isentropic processes are reversible.
R: Reversible adiabatic processes are isentropic.
R: Reversible adiabatic processes are isentropic.
- 1846 attempts
- 7 upvotes
- 10 comments
Tags :
ESE & GATE MEGeneralMar 19ESE & GATE ME