Time Left - 15:00 mins
GATE ME 2019: Topper's Quiz-6 (App update required to attempt this test)
Attempt now to get your rank among 899 students!
Question 1
Elasticity of various materials is controlled by its
Question 2
A wheel of radius 10 cm can rotate freely about its centre. A string is cropped over its rim and is pulled by a force of 5 N. It is found that torque produces an angular acceleration 2 rad/s2 in wheel. The moment of inertia of the wheel is _________.
Question 3
The below given fig. is device used for ;
Question 4
For counter flow heat exchanger with one of the fluid remains in its stagnation temperature, the effectiveness of the heat exchanger is 0.643. If overall heat transfer coefficient is 40 W/m2℃ and the smaller heat capacity value is 245 and diameter of the 140 tubes is 20 mm. What will be the length of the tube?
Question 5
The following data is given for a hydrodynamic bearing:
Length to diameter ratio- 1
Journal speed- 1500 rpm
Diametric clearance-
Journal diameter- 50 mm
External load- 6 kN
The value of minimum film thickness variable is 0.4 and corresponding Sommerfeld number is 0.121. The viscosity (in centipoise) of oil that need to be used is
Length to diameter ratio- 1
Journal speed- 1500 rpm
Diametric clearance-
Journal diameter- 50 mm
External load- 6 kN
The value of minimum film thickness variable is 0.4 and corresponding Sommerfeld number is 0.121. The viscosity (in centipoise) of oil that need to be used is
Question 6
In a Lagrangian system, the position of a fluid particle in a flow is described as and where t is the time while and k are constants. The flow is
Question 7
A solid copper ball of mass 0.5 kg when quenched in a water bath at 300C, cools from 5300C to 4300C in 10 seconds. What will be the temperature (0C) of the ball after the next 10 seconds?
Question 8
A manufacturer has the following data regarding a product:
Fixed cost per month = Rs. 50000
Variable cost per unit = Rs. 200
Selling price Per unit = Rs. 300
Production capacity = 1500 units per month
If the production is carried out at 80% of the rated capacity, then the monthly profit (in Rs.) is________
Fixed cost per month = Rs. 50000
Variable cost per unit = Rs. 200
Selling price Per unit = Rs. 300
Production capacity = 1500 units per month
If the production is carried out at 80% of the rated capacity, then the monthly profit (in Rs.) is________
Question 9
The maximum reduction in cross-sectional area per pass (R) of a cold wire drawing process is
where n represents the strain hardening coefficient. For the case of a perfectly plastic material, is
where n represents the strain hardening coefficient. For the case of a perfectly plastic material, is
Question 10
The central deflection of the uniform bend shown in figure is _________.
- 899 attempts
- 8 upvotes
- 4 comments
Tags :
ESE & GATE MEGeneralOct 23ESE & GATE ME