Time Left - 35:00 mins
GATE 2019: Topper Quiz 15 (App update required to attempt this test)
Attempt now to get your rank among 275 students!
Question 1
In UJT relaxation oscillator the value of R = 5kΩ, C = 0.065μF, intrinsic stand off ratio, ŋ = 0.65. The frequency of this UJT relaxation oscillator is ……………….kHz.
Question 2
Consider a unity feedback system with forward transfer function given by
The steady-state error in the output of the system for a unit-step input is __________ (upto 2 decimal places).
Question 3
A digit timer counter possesses a base clock of frequency 100 MHz. When measuring a particular input, the reading obtained is the same in: (i) Frequency mode of operation with a gating time of one second and (ii) Period mode of operation (in the x 10 ns scale). The frequency of the unknown input (reading obtaineD. in Hz is _______.
Question 4
A 6-pole, 3-ɸ induction motor is connected to a 25 Hz supply and at full load the rotor e.m.f. makes 110 complete cycles in 2 minutes the full load percentage slip is
Question 5
In a rotor fed induction motor, the speed of stator magnetic field with respect to rotor will be
Question 6
Find the magnitude of the electric field intensity in V/m at the origin due to an 8nC charge located at (2, –3, 1).
Question 7
A DC voltmeter has a sensitivity of 100 ohm/Volt. When it measures half full scale in 10 V range, the current in mA through the voltmeter will be in:
Question 8
Determine the range of the digital voltmeter in Volt with digit display that displays a voltage of 0.14253 V as 0.14 V?
Question 9
In the network shown, the switch is opened at t = 0 prior to that the network was in the steady – state find at t = 0.
Question 10
The driving point input impedance seen from the source Vs of the circuit shown below, in is__________.
Question 11
The switching wave forms of the transistor switch is shown in figure. duty cycle α is 50% and switching frequency is 10 kHz determine :
Determine time at which peak power loss during turn on process is occurs.
Determine time at which peak power loss during turn on process is occurs.
Question 12
a thyristor converter of 200kA is connected to supply mains through a di/dt inductor of reactance 7%. If current over load factor is 2.5, then the inductor power is____(KVA)
Question 13
In the system shown below,
Generator voltage is ……………..p.u.
(Assume 100 mVA and 15 kV as base values at generator terminal)
Question 14
A 15MVA, 11KV generator is directly connected to a transmission line. A short circuit occurs between the two phases of line (b and c). The positive, negative and zero sequence reactance in ohms are as follows;
The fault current in the line is….
Question 15
What will be the output if A synchronous motor connected to an infinite bUB takes power at a lag p.f. If its excitation is increased?
- 275 attempts
- 4 upvotes
- 0 comments
Tags :
ESE & GATE EEGeneralJun 6ESE & GATE EE