Time Left - 15:00 mins
Mission ISRO 2019: Measurements Quiz 1
Attempt now to get your rank among 303 students!
Question 1
A moving coil voltmeter has a range of 0 – 10 V. In order to extend the range of the voltmeter to 0 – 50 V, a multiplier resistance must be added in series with the coil. The multiplier resistance should be:
Question 2
In order to have a high current sensitivity, the control-spring constant of the moving coil ammeter should be:
Question 3
The wiper of a rotational potentiometer can have a maximum angular displacement of 330 °. When an input of 150 V is applied to the potentiometer, the wiper makes an angular displacement of 55 °. Find the output of the potentiometer.
Question 4
Instrument transformers are known to introduce magnitude and phase errors in measurements. These are primarily due to
Question 5
A current of is passed through the circuit shown in figure below. Determine the reading of electrostatic voltmeter (in Volt) across 1 mH inductor.
Question 6
Lissajous pattern on a oscilloscope, 7 vertical tangencies and 5 horizontal tangencies. If vertical frequency is 400 Hz, ________ Hz is horizontal frequency.
Question 7
The current in a circuit consist of a DC component of 10 A superimposed on a 50 Hz sinusoidal component of maximum value 10 A. The reading shown by a PMMC ammeter will be ?
Question 8
Analog inputs are converted to digital outputs using op-amps as comparators. Assuming a 5-bit digital output, the number of comparators required would be
Question 9
A 1000 Hz sinusoidal voltage is connected to both and inputs of a CRO. Which of the following waveforms is seen on CRO?
Question 10
Four ammeters and with the following specifications are available.
A current of 1 A is to be measured. To obtain the maximum error in the reading, Which meter should be selected?
A current of 1 A is to be measured. To obtain the maximum error in the reading, Which meter should be selected?
- 303 attempts
- 3 upvotes
- 3 comments
Jun 10ESE & GATE EE