Time Left - 24:00 mins
AE 2019 || Day 38 || Combined Syllabus Quiz 2
Attempt now to get your rank among 853 students!
Question 1
The effect of reduction in effective base width due to increase in reverse voltage of BJT is
Question 2
In the Wien bridge oscillator, the phase-shift is met by using lead-lag network and by using
Question 3
For a Type-2 system, the steady-state errors for unit step and unit ramp input are
Question 4
The magnitude and phase relationship between the sinusoidal input and the steady-state output of a system is called as
Question 5
Add 8 and 9 in BCD code
Question 6
Convert the binary number 11000110 to Gray code
Question 7
Which among the following A.C. bridges are used for precise measurements?
Question 8
The expression for Quality factor in Maxwell’s bridge will be:
Question 9
Two capacitance, C1 = 150 ± 2.4 μF and C2 = 120 ± 1.5 μF are connected in parallel. What is the limiting error of the resultant capacitance C?
Question 10
A supply of 250 V, 50 Hz is applied to a series RC circuit. If the power absorbed by the resistor be 400 W at 160 V, the value of the capacitor C will be nearly
Question 11
Consider the following equations:
V1 = 6V2 – 4I2
I1 = 7V2 – 2I2
A, B, C and D parameters are
V1 = 6V2 – 4I2
I1 = 7V2 – 2I2
A, B, C and D parameters are
Question 12
In a series RC circuit, the values of R = 10 Ω and C = 25 nF A. sinusoidal voltage of 50 MHZ is applied and the maximum voltage across the capacitance is 2.5 V. The maximum voltage across the series combination will be nearly
Question 13
A 50 Hz sinusoidal voltage V = 311 sin ωt is applied to an RL series circuit. If the magnitude of resistance is 5 Ω and that of the inductance is 0.02 H, the r.m.s. value of the steady-state current and the relative phase angle are nearly
Question 14
Which one of the following faults occur more frequently in a power system?
Question 15
Identify the type of transformers used in the figure
Question 16
For an extra-high voltage overhead trans-mission line, four conductors are used per phase (in a bundle) at the corners of a square of side ‘s’ metre. The GMR (Geometric Mean Radius) of each conductor is r’m metre.
Question 17
In a single phase diode bridge rectifier with ripple free load current supplies an inductive loaD. What will be the current waveform at ac side?
Question 18
In a Single-phase semi converter bridge with R-L-E Load, the purpose of freewheeling diode is to:
Question 19
A 500 kVA transformer has an efficiency of 95% at full load and also at 60% of full load, both at upf. The efficiency η of the transformer at 3/4th full load at upf will be nearly
Question 20
What is the useful flux per pole on no load of a 250V, 6 pole shunt motor having a wave connected armature winding with 110 turns, armature resistance of 0.2 Ω and armature current 13.3 A at no load speed of 908 rpm?
- 853 attempts
- 4 upvotes
- 4 comments
Tags :
ESE & GATE EEGeneralNov 10ESE & GATE EE