Time Left - 08:00 mins
BHEL ET Civil 2019: Technical Power Quiz 3
Attempt now to get your rank among 841 students!
Question 1
Which of the following represents steady flow
Question 2
The collapse load for the cantilever, shown in figure, will be
Question 3
Which of the following is most important for the hydraulic jump to be formed?
Question 4
For an isotropic material, the relationship between Young’s Modulus(E), Shear Modulus(G), and Poisson’s ratio () is given by
Question 5
As per IS 456-2000; in the limit state design of a flexural member, the strain in reinforcing bar under tension at ultimate state should not be less than
Question 6
What is the capillary pressure in a fine grained soil with effective size of 0.004mm?
Question 7
Built up sections essentially required for a compression member is
Question 8
Most economical circular section is designed for
Question 9
What is a Mullion in a window shutter?
Question 10
In double diamond bolting, for plate of width B and bolt diameter d the efficiency of the joint is approximately given by
Question 11
A soil sample is subjected to a hydrostatic pressure, The Mohr circle for any point in the soil sample would be
Question 12
For connecting lacing flat to column section with M20 bolts, the minimum width of flat (in mm) should be
Question 13
The plasticity characteristics of clays are due to
Question 14
A propped cantilever is subjected to a concentrated load of 16 kN at the centre of the span. The length of beam is 4 m. The flexural rigidity EI = 4 x 102 kNm2. The reactions at the fixed end and simply supported end are:
Question 15
A moment ‘K’ required to rotate near end of a prismatic beam through a unit angle without translation, the far end being freely supported is given by:
- 841 attempts
- 4 upvotes
- 7 comments
Tags :
ESE & GATE CEGeneralDec 22ESE & GATE CE