Time Left - 15:00 mins
GATE 2020: Strength of Material Quiz 1
Attempt now to get your rank among 2265 students!
Question 1
If the ratio G/E (G = Rigidity modulus, E = Young’s modulus of elasticity) is 0.4, then what is value of the Poisson ratio?
Question 2
The maximum strain energy corresponding to the stress at the elastic limit is known as ____
Question 3
In the arrangement as shown in the figure, the stepped steel bar ABC is loaded by load P. The material has young’s modulus E= 200 GPa and the two portions AB and BC have area cross section 1cm2 and 2cm2 respectively. The magnitude of load P required to fill up the gap of 0.75 mm is 
Question 4
A rectangular region in a solid is in a state of plane strain. The (x,y) coordinates of the corners of the under deformed rectangle are given by P(0,0), Q (4,0), S (0,3). The rectangle is subjected to uniform strains,
The deformed length of the elongated diagonal, up to three decimal places, is _________ units.
The deformed length of the elongated diagonal, up to three decimal places, is _________ units. Question 5
A steel rod of cross-sectional area 10 mm2
Is subjected to loads at points P, Q, R and S as shown in the figure below:
If Esteel = 200 GPa, the total change in length of the rod due to loading is
Is subjected to loads at points P, Q, R and S as shown in the figure below:
If Esteel = 200 GPa, the total change in length of the rod due to loading is
Question 6
The pressure on the fluid is 3 MPa. The Young’s modulus is 210 GPa and the Poisson’s ratio is 0.25, the volumetric compressive strain produced is
- 2265 attempts
- 8 upvotes
- 37 comments
Jun 29ESE & GATE ME
