Time Left - 08:00 mins
SSC JE 2019-20: Technical Quiz 13
Attempt now to get your rank among 634 students!
Question 1
The flow through a circular pipe is laminar. Now, the fluid through the pipe is replaced with a more viscous fluid and passed through the pipe again with the same velocity. What can we say about the nature of this flow?
Question 2
A closed system receives 60 kJ heat but its internal energy decreases by 30 kJ. Then the work done (in KJ) by the system is _____.
Question 3
Match List-I (Alloying Element) with List-II (Effect on Steel) and select the correct answer using the codes give below the lists:
List-I
[A]. Vanadium
[B]. Molybdenum
[C]. Silicon
[D]. Chromium
List-II
[1]. Increases endurance strength
[2]. Improves creep properties
[3]. Increases hardness
[4]. Increases resistance to high temperature oxidation
List-I
[A]. Vanadium
[B]. Molybdenum
[C]. Silicon
[D]. Chromium
List-II
[1]. Increases endurance strength
[2]. Improves creep properties
[3]. Increases hardness
[4]. Increases resistance to high temperature oxidation
Question 4
For a polished glass tube of , what will be the approximate rise in capillary if the containing liquid is water at?
Question 5
A wall surface of 200 mm thickness has an outside temperature of 50 °C and inside temperature of 25 °C with thermal conductivity of 0.51 W/mK. The heat transfer through this wall will be
Question 6
Match List-I with List-II and select the correct answer using the code given below the lists:
Question 7
A reversible heat engine is operating between the temperature limits of 606
And 20. The work done by the engine per 2kJ input of heat is
Question 8
For a strain gauge (gauge factor = 2.1 and resistance = 50), subjected to a maximum strain of 0.001, the maximum change in resistance is
Question 9
An ideal closed-cycle gas turbine plant is working between the temperatures 927 °C and 27 °C using air as working fluid. The pressure ratio for maximum output is
Question 10
Thickness of a steel plate is reduced from 20mm to 10mm by passing it through rolls of diameter 300mm in a multipass rolling operation. If the coefficient of friction is 0.1, then calculate the minimum number of passes required.
- 634 attempts
- 1 upvote
- 5 comments
Tags :
ESE & GATE MEGeneralApr 2ESE & GATE ME