Time Left - 08:00 mins
SSC JE 2019-20: Surveying Quiz-6
Attempt now to get your rank among 1091 students!
Question 1
A 20 m chain was found to be 20 cm too long after chaining a distance of 2500 m. It was found to be 28 cm too long at the end of the day’s work after chaining a total distance of 4000 m. What is the true distance (in m, correct to one decimal digit) if the chain was correct before the commencement of the day’s work?
Question 2
If the area calculated by chain is found to be 0.6 link too long is 140 acres then the true area (in acres)
Question 3
Calculate the temperature correction for a tape if the tape was standardized at 25°C Assume that the observation was recorded at 30°C and coefficient of thermal expansion of the tape is 1.2 × 10–5 per ˚C and standard length of the tape is 20 m.
Question 4
A survey line cuts the river on the opposite bank at A and B. To measure the distance AB a point C is taken on the same side of river as A. two offsets AD and CE are erected perpendicular to AB on A and C respectively such that B, D and E are ranged on a single line. Determine the width of river if AD = 125m, CE = 150 m and AC = 100 m.
Question 5
A chain was designated to be 30 m long was found to be 0.2 m too long. If the measured length of chain is 354.89 m, what will be the true length
Question 6
Match list 1 with list 2 and select the answers using the codes given below.
List-I
(a) Main survey line
(b) Tie line
(c) Base line
(d) Proof line
List-II
i. Passer through centre of area
ii. Used to locate the interior details
iii. liner joining the boundary points of the area
iv. To check accuracy of the field work
Question 7
What is the maximum tolerance for a 20 m chain
Question 8
Reconnaissance in the survey refers to
Question 9
Hypotensuall allowance is given by the expression:
Question 10
The error which occurs due to bad ranging is called
- 1091 attempts
- 1 upvote
- 11 comments
Tags :
ESE & GATE CESurveyingJul 7ESE & GATE CE