Time Left - 08:00 mins
SSC JE 2019 - 20 technical Quiz 66
Attempt now to get your rank among 987 students!
Question 1
If the demand for an item is four times and the ordering cost halved, the economic order quantity
Question 2
In a four-bar-linkage, if smallest link is S, longest link is L and other two connecting links are P and Q, then condition such that no link rotates fully is
Question 3
Which of the following is not related to soldering operation:
Question 4
Diesel Engine is form of:
Question 5
The height of the down-sprue is 175 mm and its cross-sectional area at the base is 200 mm2. The cross-sectional area of the horizontal runner is also 200 mm2 assuming no losses, indicate the correct choice for the time (in seconds) required to fill a mold cavity of volume 106 mm3. (Use g = 10 m/s2).
Question 6
Which one of the following non-dimensional numbers is used for transition from laminar to turbulent flow in free convection?
Question 7
Match List-I (Measuring instrument) with List-II (Variable to be measured) and select the correct answer using the codes given below the lists:
List-I
A) Hot wire anemometer
B) Pitot tube
C) V-notch weir
D) Tachometer
List-II
1) Discharge
2) Rotational speed
3) Velocity fluctuations
4) Stagnation pressure
List-I
A) Hot wire anemometer
B) Pitot tube
C) V-notch weir
D) Tachometer
List-II
1) Discharge
2) Rotational speed
3) Velocity fluctuations
4) Stagnation pressure
Question 8
In a strained material one of the principal stresses is twice the other. The maximum shear in the same cases is . Then, what is the value of the maximum principal stress?
Question 9
Air-conditioning has to be done for a hall whose RSH = 50 kW and RLH = 50 kW. There are no other sources of heat addition or leakages. What is the value of the RSHF?
Question 10
In Blanking, clearance is provided on ____.
- 987 attempts
- 7 upvotes
- 15 comments
Tags :
ESE & GATE MEGeneralOct 13ESE & GATE ME