Time Left - 08:00 mins
SSC JE 2019-20 Technical Quiz 81
Attempt now to get your rank among 1366 students!
Question 1
The unit of surface tension is
Question 2
Match List-I with List-II and select the correct answer using the codes given below the lists:
List-I
[A]. Elasticity
[B]. Malleability
[C]. Ductility
[D]. Plasticity
List-II
[1]. Deform non elastically without fracture
[2]. Undergo plastic deformation under tensile load
[3]. Undergo plastic deformation under compressive load
[4]. Return to its original shape on unloading
List-I
[A]. Elasticity
[B]. Malleability
[C]. Ductility
[D]. Plasticity
List-II
[1]. Deform non elastically without fracture
[2]. Undergo plastic deformation under tensile load
[3]. Undergo plastic deformation under compressive load
[4]. Return to its original shape on unloading
Question 3
Which of the following can possibly represent an adiabatic process?
Question 4
The tendency of a diesel engine to knock increases, if
Question 5
Which among the following is not an example of multi cutting tool?
Question 6
In an orthogonal cutting process the tool used has rake angle of zero degree. The measured cutting force and thrust force are 500 N and 250 N, respectively. The coefficient of friction between the tool and the chip is _________
Question 7
The time by which the activity completion time can be delayed without affecting the start of succeeding activities, is known as
Question 8
The strength of a brazed joint
Question 9
Cold working of steel is defined as working
Question 10
A 0.9 m long plate is welded by manual metal arc welding process using welding current of 150A, arc voltage of 20V and welding speed of 5 mm/s. If the process efficiency is 0.8 and surface resistance is 36 micro-ohm, the heat input
(in J/mm) will be____?
- 1366 attempts
- 3 upvotes
- 27 comments
Tags :
ESE & GATE MEGeneralJun 3ESE & GATE ME