Time Left - 08:00 mins
SSC JE 2019-20 Technical Quiz 91
Attempt now to get your rank among 1127 students!
Question 1
A motion is aperiodic at what value of the damping factor______?
Question 2
Two plates are joined together by means of single transverse and double parallel fillet welds as shown in the given figure. If the size of fillet is 5 mm and allowable shear load per mm is 300 N, what is the approximate length of each parallel fillet?
Question 3
In a strained material one of the principal stresses is twice the other. The maximum shear stress in the same case is 
. Then, the value of the maximum principal stress is
. Then, the value of the maximum principal stress is Question 4
In an isolated system_____
Question 5
Sling psychrometer is used to measure____
Question 6
Which one of the following statements is correct for the application of fin?
Question 7
Degree of reaction in a turbine is the ratio of ________.
Question 8
The kinetic energy correction factor for laminar flow in pipe closest to
Question 9
Which one of the following is the correct temperature range for hot extrusion of copper?
Question 10
What are the materials which show direction dependent properties, called?
- 1127 attempts
- 6 upvotes
- 7 comments
Tags :
ESE & GATE MEGeneralDec 9ESE & GATE ME
