Time Left - 15:00 mins
GATE ME 2021 || Manufacturing Quiz 9
Attempt now to get your rank among 514 students!
Question 1
The fit on a hole shaft basic system is specified as H7-q5 then this fit belongs to
Question 2
An error of 5% occurred during the measurement of the dia of a cylindrical part. The likely error in the calculated weight of the part is approximately:
Question 3
The dimension limits on a shaft of 25 h7 are
Question 4
The maximum interference in mm after assembly between a bush of size mm and shaft mm of size is __________.
Question 5
The diameter of a recessed ring was measured by using two spherical balls of diameter d2 = 60 mm and d1 = 40 mm as shown in the figure.
The distance H2 = 35.55 mm and H1 = 20.55 mm. The diameter (D, in mm) of the ring gauge is
The distance H2 = 35.55 mm and H1 = 20.55 mm. The diameter (D, in mm) of the ring gauge is
Question 6
A fit is specified as 25 H8/e8. The tolerance value of both shaft and hole for a nominal diameter of 25 mm in IT8 is 33 microns and fundamental deviation for the shaft is –40 microns. The maximum clearance of the fit in microns is
- 514 attempts
- 1 upvote
- 4 comments
Sep 28ESE & GATE ME