Time Left - 12:00 mins
SSC JE EE : Technical Quiz 11
Attempt now to get your rank among 461 students!
Question 1
Let self-inductances of two coils are L1 = 2 H and L2 = 8 H. The coil L1 produces a magnetic flux of 80 µWb of which only 60 µWb are linked with the coil L2. Calculate the mutual inductance of the two coils.
Question 2
Which type of welding is used on Bridges?
Question 3
The resistance potential divider method and capacitance potential divider method is used for
Question 4
In a forward-biased photo diode, with increase in incident light intensity, the diode current______.
Question 5
The charging current drawn by the cable ___________.
Question 6
In which of the following motors is torque produced due to the tendency of the rotor to align itself in the minimum reluctance position when the speed of the motor is close to the synchronous speed?
Question 7
Convert (0.7854)10 to binary.
Question 8
Which of the following is the main disadvantage of conduit wiring?
Question 9
A Potential Transformer is device which is
Question 10
The minimum dielectric stress in a cable is at
Question 11
It is defined as the degree of the measurement system. It indicates changes in the measure and without any dynamic error.
Question 12
For a three-phase short circuit fault the fault MVA (Short Circuit Capacity) is defined as:
Short circuit capacity = VI, where V & I are respectively
Question 13
Magnetic flux has the unit of
Question 14
For current I (t), the electrodynamometer ammeter will read
Question 15
A voltmeter measures a full scale voltage of 100 V produces a full scale error at 10 %. Find the error it voltmeter reads 50 V.
Question 16
Which one of the following cable is best suited for underground transmission at a voltage of 132 kV?
Question 17
Which among these is common defect in a commutator?
Question 18
By using bundling of conductor, which of the following result are correct:
(I) Corona loss reduced
(II) XL Reduced
(III) XC Increases
(IV) Surge Impedance loading Increased
(V) Cost of transmission is reducing
Question 19
Which of the following is not a limitation of Merz Price protection method.
Question 20
In the current transformer burden is _______?
- 461 attempts
- 1 upvote
- 1 comment
Tags :
AE & JE ExamsDec 16AE & JE Exams