A mass m1 of 100 kg travelling with a uniform velocity of 5 m/s along a line collides with a stationary mass m2 of 1000 kg. After the collision, both the masses travel together with the same velocity. The coefficient of restitution is
Question 2
In which one of the following is a flywheel generally employed?
Question 3
3 kg of water initially in saturated liquid state at 2 bar, 25°C[vf = 0.231/m3/kg, uf = 520 kJ/kg, hf = 510 kJ/kg, hg = 2399 kJ/kg]. Heat is added isobarically such that temperature of water raises to 420°C [h = 3385 kJ/kg, u = 2520 kJ/kg, v = 0.058 m3/kg]. Calculate the heat added during the process (in kJ)_______.
Question 4
Calculation of metacentric height of a floating body involves second moment of area. The axis about which this moment is to be calculated passes though the
Question 5
A long cylindrical pipe is wrapped with an insulating material. Up to the critical radius of insulation ________.
Question 6
Given that the peripheral speed of the grinding wheel of 100 mm diameter for cylindrical grinding of a steel workpiece is 30 m/s, what will be the estimated rotational speed of the grinding wheel in revolution per minute (rpm)?
Question 7
In terms of physical significance, The size of a cam depends upon,
Question 8
A linear programming problem with mixed constraints (some constraints of ≤ type and some of ≥ type) can be solved by which of the following methods?
Question 9
Match List-I with List-II and select the correct answer using the codes given below the lists: List-I A. Lubricantion B. Rise of water in trees C. Formation of droplets D. Cavitation Lists-II 1. Capillary 2. Vapour pressure 3. Viscosity 4. Surface tension
Question 10
Effective length for a column is more under which of the following condition?
Question 11
The total area under the stress-strain curve of a mild steel specimen tested up to failure under tension is a measure of
Question 12
The Sommerfeld number is given by __________. Where: r = radius of journal c = radial clearance μ = viscosity of lubricant (N-s/mm2) ns = journal speed (rev/s) p = unit bearing pressure (N/mm2)
Question 13
Which one of the following statements is correct for the application of fin?
Question 14
A box of weight 1000 N is placed on the ground. The coefficient of friction between the box and the ground is 0.5. When the box is pulled by a 100 N horizontal force, the frictional force developed between the box and the ground at impending motion is
Question 15
On a particular day, the atmospheric air was found to have dry bulb temperature of 30oC and wet bulb temperature of 18oC. The barometric pressure was observed to be 756mm of Hg and partial pressure of water vapour as 9.62 mm Hg. Find the specific humidity in gm/kg of dry air.
Question 16
Match List-I (Type of Gears) with List-II (characteristics) and select the correct answer using the code given below the lists: List-I A) Helical gearing B) Herringbone gearing C) Worm gearing D) Hypoid gearing List-II 1) Zero axial thrust 2) Non-inter-changeable 3) Skew shafts 4) Parallel shafts
Question 17
What is the correct sequence of operations in powder metallurgy?
Question 18
A closely coiled helical spring is cut into two equal parts. What will be the ratio of the deflection of any of the resulting spring to the deflection of the original spring for the same load?
Question 19
For the given epicyclic gear train if the Gear A is fixed and Arm C makes 20 revolutions, the number of revolutions made by Gear B will be ________.
Question 20
The velocity component in x and y direction are given by u= λxy-xy2 ; v= x2y – 4y3 , the value of λ for the point(1,1) when the flow is possible and fluid is incompressible?
Question 21
Fluidity of liquid metal in a spiral test can be increased by
Question 22
If young’s modulus of elasticity of a material is 140 GPa and Bulk modulus is 70 GPa, what will be the Poisson’s ratio (μ)?
Question 23
A circular object of radius r rolls without slipping on a horizontal level floor with the center having velocity V. The velocity at the point of contact between the object and the floor is
Question 24
For the same friction lining material and applied load, what will be the ratio of torque carrying capacity calculated using Uniform pressure theory and Uniform wear theory if clutch plates are solid ( Ri = 0) _________.
Question 25
A motion is aperiodic at what value of the damping factor______?
Question 26
Consider the following statements: in an epicyclic gear train with 96 and 36 number of teeth on the annulus and sun respectively 1) Planet must have 30 teeth 2) There must be 3 or 4 planets around the circumference 3) Planets can never be input or output links 4) Module of the sun should be more than the rest Which of these statements are correct?
Question 27
In ASA system, if 10 – 8 – 6 – 6 – 10 – 12 - 2 mm, then principle cutting edge angles is
Question 28
The coupling used to connect two shafts with large angular misalignment is____.
Question 29
The maximum theoretical work obtainable, when a system interacts to equilibrium with a reference environment, is called __________.
Question 30
What are the forces that influence the problem of fluid statics ?
Question 31
Which one of the given responses would be the meaningful order of the following words?
1) Consultations 2) Illness 3) Doctor 4) Treatment 5) Recovery
Question 32
In the following question, select the missing number from the given alternatives.
17, 32, 60, 114, 220, ?
Question 33
In the following figure, rectangle represents Web designers, circle represents Equestrians, triangle represents Poets and square represents Joggers. Which set of letters represents joggers who are both Equestrians as well as Poets?
Question 34
Pritam got more marks than Krishna who got less marks than Anuj. Anuj got less marks than Pritam. Rishi got less marks than Krishna but more marks than Khusbu then who got second highest marks?
Question 35
In the following question, select the related number from the given alternatives. 42 : 14 : : 56 : ?
Question 36
In the following question, select the related word from the given alternatives.
Happy : Sad :: Benevolent : ?
Question 37
In the following question, select the odd letters from the given alternatives.
Question 38
Arrange the given words in the sequence in which they occur in the dictionary. 1) Philosopher 2) Pharmacy 3) Piercing 4) Salesman 5) Saleswoman
Question 39
In the following question, select the related number from the given alternatives. 24 : 4 :: 72 : ?
Question 40
Which is the letter opposite to the letter C in the cube? Question figure:
Question 41
In the following question, select the odd word from the given alternatives.
Question 42
A series is given with one term missing. Select the correct alternative from the given ones that will complete the series.
4, 5, 6, 9, 8, 13, 10, ?
Question 43
In the following question, select the odd letters from the given alternatives.
Question 44
Rearrange the jumbled letters to make a meaningful word and then select the one which is different.
Question 45
In a certain code language, if BOARD is coded as 45136 and CHALK is coded as 78129, then BLOCK will be coded as -
Question 46
Vernacular press act was passed during the time of _____.
Question 47
Which acid is present in Coconut oil?
Question 48
Which layer of the earth has the lowest temperature?
Question 49
Who appoints Advocate General of State in India?
Question 50
What is the phenomenon of organisms resembling others to escape from enemies called?
Question 51
Which of the following enzyme is secreted by pancreas?
Question 52
Lord Dalhousie served as Governor general of India from 1848 to ______.
Question 53
Which Union Ministry has launched the new company incorporation form "SPICe+"?
Question 54
Radhaswami movement was initiated by?
Question 55
Prolactin hormone is released by which gland?
Question 56
Magnetic Field is a quantity which has________.
Question 57
Who was the British Prime Minister at the time of Quit India Mvement?
Question 58
Anthelminthic medicines are used for which of following?
Question 59
The number of protons and neutrons in protium is respectively _____ & _____.
Question 60
The air bubble in water shines due to which of the following phenomena?