Time Left - 30:00 mins
GATE 2021 ME : Toppers Quiz 14
Attempt now to get your rank among 679 students!
Question 1
A circular disc of radius r rolls without slipping at velocity v. The magnitude of velocity at topmost point is
Question 2
A man goes from A to B at V1 speed return from B to A at V2 speed, find Average Speed
Question 3
The chemical formula for R-134 is:
Question 4
If the moment of inertia about the centroidal axis of a circular cross section is known, then its polar moment of inertia can be calculated using
Question 5
The minimum temperature achieved by a desert cooler is?
Question 6
Equivalent resistance of the thermal circuit given in the figure _________.
Question 7
Design a side cylindrical riser to feed a cubical casting of 20 cm side. Taking shrinkage of material as 6%, then radius of the riser is ___________mm (consider riser volume to be at least 3 times the shrinkage volume)
Question 8
If there are two materials A & B, for material “A”, Young’s modulus is twice the Shear modulus & for “B” Young’s modulus is thrice the bulk modulus, then μA & μB respectively are
Question 9
In a transportation problem, the materials are transported from 4 plants to 6 warehouses. The basic feasible solution must contain exactly, which one of the following allocated cells ?
Question 10
A bracket (shown in figure) is rigidly mounted on wall using four rivets. Each rivet is 6mm in diameter and has an effective length of 12mm.
Direct shear stress (in MPa) in the most heavily loaded rivet is
Direct shear stress (in MPa) in the most heavily loaded rivet is
Question 11
Consider the following statements:
Helical gears may be designed in applications where gears are to be mounted on
1) Non-parallel shafts.
2) Parallel shafts.
3) Intersecting shafts.
4) Non-parallel and non-intersecting shafts.
Which of these statements is/are correct?
Helical gears may be designed in applications where gears are to be mounted on
1) Non-parallel shafts.
2) Parallel shafts.
3) Intersecting shafts.
4) Non-parallel and non-intersecting shafts.
Which of these statements is/are correct?
Question 12
Which of the following sheet metal operation induced only compressive stresses in the part?
Question 13
Match the differentials in list 1 with the corresponding differentials in list 2
List-1
A).
B).
C).
List-2
1) . −
2).
3).
Question 14
The size of the lathe is expressed by which of the following?
Question 15
Match List-1 (Properties) with List-2(Type)
List-1
(1). Density
(2). Refractive index
(3). Internal energy
(4). Specific enthalpy
List-2
(A). Intensive
(B). Extensive
- 679 attempts
- 3 upvotes
- 3 comments
Tags :
ESE & GATE MEGeneralJan 11ESE & GATE ME