GATE 2021 ME : Toppers Quiz 10 (App update required to attempt this test)
Attempt now to get your rank among 709 students!
Question 1
The work done by a body in moving down a smooth inclined plane in comparison to being dropped vertically downwards from same height will be
Question 2
0.1 kg block is resting on a surface with the coefficient of friction=0.35, a force of 1 N is applied on the block, the friction force will be?
Question 3
Steel whose elements are used for the purpose of modifying the mechanical properties of plain carbon steel is called ___________.
Question 4
In steel, main alloy causing corrosion resistance is ________.
Question 5
A 13 m ladder is placed against a smooth vertical wall with its lower end 5 m from the wall. What should be the coefficient of friction between the ladder and floor so that it remains in equilibrium?
Question 6
A block made of perfectly plastic material with a yield stress of 260 MPa in simple tension has the diameter 200 mm × 100 mm × 150 mm (b × h × w) at one instant during plane strain forging. Assuming there is sticking friction, the peak pressure will be
Question 7
For ball bearings, the fatigue life L measured in number of revolutions and the radial load F are related by , where K is a constant. It withstands a radial load or 2 kN for a life of 540 million revolutions. The load (in kN) for a life of one million revolutions is _______
Question 8
A bolted joint has four bolts arranged as shown in figure. The cross sectional area of each bolt is 25 mm2. A torque T = 200 N-m is acting on the joint. Neglecting friction due to clamping force, maximum shear stress in a bolt is_____ MPa.
Question 9
Just-In-Time production is also known as _______.
Question 10
Match list-I with List-II and select the correct answer using the codes given below the list:
List –I
(Material properties)
A) Ductility
B) Toughness
C) Endurance limit
D) Resistance to penetration
List-II
(Test to determine properties)
1) Impact test
2) Fatigue test
3) Tension test
4) Hardness test
Question 11
Air flows over a 10 m long plate. The transition from laminar to turbulent flow takes place between Reynolds number of 2.5 × 106 and 3.6 × 106. What is the maximum distance from the front edge of the plate along which one can expect laminar flow in the boundary layer? The free stream velocity is 30 m/s and kinematic viscosity (ν)= 1.5 ×10-5 m2/s.
Question 12
For an ideal gas, the slope of the constant volume line is _______ than that of constant pressure line on the T-s diagram.
Question 13
Gun metal consists of
Question 14
In a psychrometric chart, relative humidity lines are:
Question 15
The vibration analysis of a physical system may be summarized by