Time Left - 30:00 mins
GATE 2021 ME : Toppers Quiz 9 (App update required to attempt this test)
Attempt now to get your rank among 681 students!
Question 1
During torsional vibration of a shaft the node is characterized by the____
Question 2
The equation represents.
Question 3
Two identical trusses support a load of 200N as shown in the figure. The length of each truss 1.5 m, cross-sectional area is 180 mm2; young’s modulus E= 210GPa. The force in the truss AB is ________.
Question 4
The figure shows a plane truss having a vertical downward force of P applied at joint B. FED is
Question 5
In vibration isolation system, if , then for all values of damping factor, the transmissibility will always be _____
Question 6
In which of the following non-traditional machining processes, tool wear doesn’t occur?
Question 7
It is required to design a Hydrodynamic journal bearing for a bearing pressure of 1.7 N/mm2. The load carried by the bearing is 8330 N. If the length of the journal is 70 mm. what is type of bearing?
Question 8
A Particular section of steel shaft is subjected to maximum bending stress of 160 MPa and a maximum shear stress equal to 60 MPa. The yield point in tension of the material is 400 MPa. If maximum principal stress theory is used, the FOS will be _______.
Question 9
The maximum blade efficiency of a reaction steam turbine having a nozzle angle of is _________
Question 10
A cam with an ascent angle of 120 and maximum displacement of follower of 20 mm is rotating with an angular velocity of 88 rad/s and has a descent and then followed by dwell. If cam follower program has a constant acceleration then find the value of maximum velocity during ascent of the follower (in m/s) ________.
Question 11
The velocity of flow field is V = . What is the vorticity vector at (1,1,1)?
Question 12
Two heat engines are connected in series in such a way that rejected heat of 1st engine is directly fed to 2nd engine. If the source temperature is 1600 K and sink temperature is 400 K. Then calculate intermediate temperature If both the engine have same efficiency.
Question 13
A circular plate of diameter 1.5 m which is placed vertically in water in such a way that the centre of the plate is 3 m below the free surface of water.The position (in mm) of centre of pressure from the free surface is _____.
Question 14
Which of the following unit cells are arranged in ascending order of atomic packing factor? (The abbreviations used are BCC = Body Centred Cubic, FCC = Face Centred Cubic, SC = Simple Cubic, HCP = Hexagonal Closed Packed)
Question 15
A simply supported beam AB shown below is loaded with a couple μ at the end B . For the given beam, the equation of the elastic curve will be ______.
- 681 attempts
- 3 upvotes
- 9 comments
Tags :
ESE & GATE MEGeneralJul 22ESE & GATE ME