Time Left - 12:00 mins
BARC Quiz 4
Attempt now to get your rank among 146 students!
Question 1
The bandwidth required in DPCM is less than that of PCM because
Question 2
For the given circuit, the Open circuit Parameter of two-port network ''N'', are Z11 = 4; Z12= 3; Z21= 3; Z22= 2 . Find the value of Currents I1 & I2, if the input voltage Vo = 3∠ having an impedance Z0 as 5Ω and load current IL has an impedance ZL of 4Ω?
Question 3
Match List-I with List-II and select the correct answer using the code given below the Lists:
List-I
A). 555
B). 74173
C). 74163
D). 8097
List-II
1). Microcontroller
2). Register
3). Timer
4). Counter
List-I
A). 555
B). 74173
C). 74163
D). 8097
List-II
1). Microcontroller
2). Register
3). Timer
4). Counter
Question 4
If the value of a resistor creating thermal noise is doubled. The noise power generated is therefore
Question 5
If the characteristic equation of a feedback control system is given by.
s4 + 20s3 + 15s2 + 2s + K = 0
then the range of values of K for the system to be stable will be
s4 + 20s3 + 15s2 + 2s + K = 0
then the range of values of K for the system to be stable will be
Question 6
PAM signals are constructed by using a low pass fitter of pass band slightly greater then band to avoid aliasing. This avoids distortion.
Question 7
The driving point impedance of the circuit shown is given by
Z(s)= 2s/(10s2+s+20)
The component values R, L and C are respectively:
Question 8
TRAP is an interrupt in 8085. Which one of the following statements is true about the TRAP?
Question 9
Which of the following quantities cannot be measured/determined using Hall effect?
Question 10
In the BJT circuit, VCC =9V ,VCE Sat=0.3V RM is 18Ω. Find the higher ICvalues?
- 146 attempts
- 0 upvotes
- 0 comments
Tags :
ESE & GATE ECGeneralMar 21ESE & GATE EC