Time Left - 12:00 mins
BARC Quiz 5
Attempt now to get your rank among 233 students!
Question 1
Consider the circuit shown in figure (a), the signal applied as input to the circuit is Vin [shown in figure (b)]
The voltage across diode VD is given as (Assuming diode to be ideal)
Question 2
A 12-bit ADC is operating with a 1 clock period and total conversion time is seen to be 14 always. The ADC must be of the type
Question 3
In the given circuit, the values of and respectively are
Question 4
For a double hetero junction LED emitting light at a peak wavelength of 1.3 μm has radiative and non-radiative recombination time as 40 nsec and 120 nsec respectively, then the bulk recombination lifetime will be
Question 5
Which of the following type of noise gains importance at low frequency?
Question 6
In SSB modulation system, if signal (cos 30t) is modulated with a carrier signal of frequency 850 rad /sec, then the expression for the lower side band is
Question 7
In a JK flip-flop we have J = Q’ and K = 1. Assuming that the flip-flop was initially cleared and clocked for 6 pulses, the sequence at the Q output will be
Question 8
A transmission line has a characteristic impedance of 50 Ω and a resistance of 0.1 Ω /m. if the line is distortion less, the attenuation constant (in Np/m) is
Question 9
A uniform plane wave in air impinges at 450 angles on a lossless dielectric material with dielectric constant Er.The transmitted wave propagates in a 300 direction with respect to the normal. The value of Er is
Question 10
The temperature below which certain materials are antiferromagnetic and above which they are paramagnetic is called
- 233 attempts
- 1 upvote
- 2 comments
Tags :
ESE & GATE ECGeneralMar 28ESE & GATE EC