Time Left - 09:00 mins
ISRO Quiz 11
Attempt now to get your rank among 145 students!
Question 1
Consider the root locus plot shown in below:
S1: Adding a zero between s = –1 and s = –2 would move the root locus to the left.
S2: Adding a pole at s = 0 would move the root locus to the right.
Which of the following is the correct answer?
Question 2
Determine the h-parameters of the given two-port network.
Question 3
IN an assembly language program it is written to mask RST 6.5 & unmask RST 5.5 & RST 7.5 as
MVI A, (X)H
SIM
The value of X will be
Question 4
If a p-type material with an extrinsic resistivity of 0.002 Ω –cm is used in a hall experiment. It is found that mobility of holes is 500 cm2/V-sec. Then the hall coefficient of the p-type material is approximately.
Question 5
The compensator
Would provide a maximum phase a maximum phase shift of
Would provide a maximum phase a maximum phase shift of
Question 6
Let F(x) = f(x) + where then F(e) equals
Question 7
The figure shows a binary counter with synchronous clear input. With the decoding log shown, the counter works as a
Question 8
A parallel plate waveguide is to be designed so that only TEM modes can propagate in the frequency range 0 < f < 2 GHz. The dielectric material between the plates has ϵr = 9, μr = 1. The spacing ‘d’ allowed between the parallel plates of waveguide is
- 145 attempts
- 0 upvotes
- 0 comments
Tags :
ESE & GATE ECGeneralMay 21ESE & GATE EC