Time Left - 15:00 mins
GATE (CE) 2022 #11: DESIGN OF STEEL STRUCTURES (App update required to attempt this test)
Attempt now to get your rank among 191 students!
Question 1
Which one of the following is correct?
Steel structures are ideally suitable for impact loads because they have high
Steel structures are ideally suitable for impact loads because they have high
Question 2
In a T-section shown in figure below, what is the distance of plastic neutral axis(in mm) as measured down from top?
Question 3
A prismatic beam (shape factor, S=1.5) fixed at both ends carries UDL throughout the span. What is the ratio of collapse load to yield load?
Question 4
A plate section, 300 mm x 10 mm has four staggered holes as shown in figure. The diameter of hole is 21.5 mm. The allowable axial tension will be -------kN.
[Take permissible stress of 150 N/mm2 in axial tension]
[Take permissible stress of 150 N/mm2 in axial tension]
Question 5
The ratio of tension and shear force in each bolt of the joint, as shown in figure, is _________
Question 6
A plate carrying tensile load is 150 mm wide and 10 mm thick. It is connected to a gusset plate using 20 mm diameter bolts as shown in figure. The block shear strength of the plate is _________ kN.
- 191 attempts
- 0 upvotes
- 0 comments
May 18ESE & GATE CE