Time Left - 08:00 mins
DFCCIL_CE _Quiz 58
Attempt now to get your rank among 615 students!
Question 1
A tension member in which a reversal of direct stress occurs due to loads other than wind or seismic forces, the slenderness ratio of the member should not exceed
Question 2
In a tension member if one or more than one rivet holes are off the line, the failure of the member depends upon
Question 3
A structural member subjected to tensile force in a direction parallel to its longitudinal axis, is generally known as
Question 4
For a single angle section, the area of outstanding and connected legs are 450 mm2 and 300 mm2. What will be the net area of the section?
Question 5
If the thickness of the thinnest outside plate is 20 mm, then the maximum pitch of rivets in tension will be taken as
Question 6
A steel rod of 16 mm diameter has been used as tie in a bracing system, but may be subject to possible reversal of stress due to the wind. What is the maximum permitted length of the member?
- 615 attempts
- 0 upvotes
- 7 comments
Tags :
AE & JE ExamsJul 13AE & JE Exams