Time Left - 12:00 mins
Strength Of Material: Nuclear Quiz 3
Attempt now to get your rank among 395 students!
Question 1
The maximum and minimum shear stresses in a hollow circular shaft of outer diameter 20mm and thickness 2mm. Subjected to a torque of 92.7 N.m will be
Question 2
Two shafts A and B are made of the same material. If the diameter of shaft B is twice that of shaft A, then the ratio of power which can be transmitted by shaft A to that of shaft B is
Question 3
In a propeller shaft a torque is applied. Due to this torque maximum compressive direct stress of 30
and maximum shear stress of 70
induced in a shaft, then the maximum tensile stress will be
and maximum shear stress of 70 induced in a shaft, then the maximum tensile stress will beQuestion 4
A solid circular shaft of diameter d and length L is fixed at one end and free at the other end. A torque T is applied at the free end. The shear modulus of the material is G. The angle of twist at the free end is
Question 5
A channel section of uniform thickness 5cm used as a beam. Moment of inertia of channel Ixx is equal to 51927.08 cm4 and point C is shear centre; then value of e in cm is
Question 6
Wall thickness of a thin cylinder shell of 800 mm internal diameter is 10 mm. length of the cylinder is 2m. if the shell is subjected to an internal pressure of 1.5 MPa, determine the maximum shear stress.
Question 7
A cantilever of length L, carries three loads W each at an interval of L/3 as shown in figure. If EI is flexural rigidity, then the slope at free end D is 
where 
is _____
where is _____ Question 8
The deflection at the free end of cantilever of span L due to point load at free end is observed to be 
. The strain energy stored in the bar will be
. The strain energy stored in the bar will beQuestion 9
A simply supported beam with width b and depth d carries a central load W and undergoes deflection 
at centre. If the width and depth are interchanged, then the deflection at the centre of the beam would attain the value
at centre. If the width and depth are interchanged, then the deflection at the centre of the beam would attain the value Question 10
A two-span continuous beam having equal spans each of length L is subjected to a uniformly distributed load w per unit length. The beam has constant flexural rigidity. The reaction at the middle support is
- 395 attempts
- 2 upvotes
- 0 comments
Jul 31ESE & GATE CE
