Time Left - 06:00 mins
SSC-JE ME || Machine Design 4
Attempt now to get your rank among 168 students!
Question 1
Consider the following characteristics of the brake lining material
1) It should have low wear rate
2) It should have low heat dissipation capacity
3) It should have high coefficient of thermal expansion
4) It should have high heat resistance
Select the correct option which indicates desirable properties
Question 2
If the moment due to actuating force and that due to friction force acts in the same direction, then the block brake is called _____.
Question 3
Self locking is not possible in case of
Question 4
The appropriate position of the clutch in a vehicle is
Question 5
A block–brake shown below has a face width of 300 mm and a mean co–efficient of friction of 0.25. For an activating force of 400 N, the braking torque in Nm is
Question 6
A single plate clutch is subjected to an axial force of 4 kN. The inside radius of the contact surface is 50 mm and the outside radius is 100mm. Assuming the uniform wear theory, the ratio of the average pressure to minimum pressure is______.
Question 7
Which one of the following is not a friction clutch?
Question 8
On the motors with low starting torque, the type of the clutch to be used is
Question 9
In a multiple disc clutch, if there are 6 discs on the driving shaft and 5 discs on driven shaft, the number of pairs of contact surfaces will be equal to
Question 10
For uniform wear condition of clutches, friction radius is equal to
- 168 attempts
- 0 upvotes
- 0 comments
Sep 23AE & JE Exams