Time Left - 08:00 mins
AE-JE (ME) || Machine Design Revision Quiz
Attempt now to get your rank among 39 students!
Question 1
The friction torque, transmitted in case of flat pivot bearing for uniform ratio of wear is equal to
Question 2
If the load on a ball bearing is reduced to half, then its life would be ________.
Question 3
Tearing efficiency of riveted Joint is 70% , The pitch to hole diameter ratio of rivets is
Question 4
Multi plate friction clutch is suitable for
Question 5
The included angle for V belt is usually
Question 6
The power transmitted by a belt drive is (T1=Tension on tight side, T2=Tension on slack side, where v = linear velocity, ω = angular velocity)
Question 7
A machine component is subjected to variable loading -60 MPa and +60 MPa. If the endurance strength and yield strength for the material are 200 MPa and 300 MPa, respectively, the factor of safety ( based on Soderberg equation) is______.
Question 8
A body is subjected to completely reversed stress. The maximum stress is 30 Pa. What is the stress ratio?
Question 9
According to maximum shear stress, the ratio of maximum shear stress to yield stress is equal to
Question 10
Required velocity ratio is 60:1, which of the following are recommended _________?
Question 11
The Wahl stress factor K for springs of spring index is given by
Question 12
In which option does not have application of the power screw
- 39 attempts
- 0 upvotes
- 1 comment
Feb 8AE & JE Exams