Time Left - 12:00 mins
BARC OCES 2022 Quiz 14
Attempt now to get your rank among 228 students!
Question 1
During a rolling process, a sheet of thick is rolled down to thickness. If the roll of diameter rotates at , calculate the velocity of strip at the neutral point.
Question 2
A smooth flat rectangular plate is placed edgewisw in a stream of fluid. At what fraction of the length from the leading edge would the drag force on the front portion be equal to half of the total drag force ? (Assume the boundary layer to be laminar).
Question 3
A hollow shaft of 1 m length is designed to transmit a power of 30 kW at 700 rpm. The maximum permissible angle of twist in the shaft is . The inner diameter of the shaft is 0.7 times the outer diameter. The modulus of rigidity is 80 GPa. The outside diameter (in mm) of the shaft is _______
Question 4
GO and NO-GO plug gauges are to be designed for a hole mm. Gauge tolerances can be taken as 10% of the hole tolerance. The sizes of GO and NO-GO gauge will be respectively(On the basis of workshop gauge)______.
Question 5
The shell of a boiler is 2 m in diameter and the plates are 2 cm thick. By how much % the working pressure will be reduced if the efficiency of the joint is 80% as compared to 100% efficiency
[Assume safe working stress for the shell plates as 70 MPa]
[Assume safe working stress for the shell plates as 70 MPa]
Question 6
For the cantilever beam shown below, calculate the maximum shear stress developed:
Question 7
Which of the following is incorrect with respect to increase in condenser pressure?
Question 8
A 1 kg block is resting on a surface with Coefficient of friction μ = 0.1 A force of 0.8 N is applied to the block as shown in the figure. The friction force is
Question 9
A carnot engine with 50 percent thermal efficiency is used to drive a carnot refrigerator having a coefficient of performance of 5. The energy absorbed by the engine for each kJ energy absorbed from the cold body by the refrigerator is _________kJ.
Question 10
The figure below shows a steel rod of 25 mm2 cross sectional area. It is loaded at four points, K, L, M and N. Assume Esteel =200GPa.The total change in length of the rod due to loading is
- 228 attempts
- 0 upvotes
- 3 comments
Tags :
ESE & GATE MEGeneralMar 23ESE & GATE ME