Time Left - 08:00 mins
MP Sub-Engineer ME: Trusses and Frames Quiz 9
Attempt now to get your rank among 77 students!
Question 1
A truss is said to be perfect when it satisfies the following conditions:
(Where m is number of members and j is number of joints)
Question 2
Consider the frame work shown below:
The force in member PS is __________ kN. (only magnitude)
(consider points P and Q to be hinged)
Question 3
A pin jointed frame PQRS is loaded as followed-
The force in member PS is ______ ?
Question 4
The truss PQR is as shown in fig.
Find the magnitude and nature of the force in member PQ in kN if it is carrying a load of 10kN at P.
Question 5
The force in member BC of steel truss structure shown in figure below is (Cross section of each member is A, Length of each member is ‘l’)
Question 6
Four forces of magnitudes 20 N, 40 N, 60 N and 80 N are acting respectively along the four sides of a square ABCD as shown in figure. The magnitude of resultant is
Question 7
Find the forces in the member BD of the truss shown in the figure below: (All forces are in kN):
Question 8
If in a simple 2-D truss number of joints is 6 then what is the number of the members?
Question 9
With respect to the truss shown below the force in the member No. 5 is:
Question 10
The figure shows an idealized plane truss. If a horizontal force of 300 N is applied at point A, then the magnitude of the force produced in member CD is ________N.
- 77 attempts
- 0 upvotes
- 1 comment
Apr 14AE & JE Exams