Time Left - 08:00 mins
MP Sub-Engineer ME: Metrology and Inspection Quiz 26
Attempt now to get your rank among 62 students!
Question 1
Go limit’ applied to which limit condition?
Question 2
Basic shaft is one _____.
Question 3
The following limits are specified in a limit system, to give a clearance fit between a hole and a shaft:
𝐻𝑜𝑙𝑒 = 25−0.01+0.02 𝑚𝑚 𝑎𝑛𝑑 𝑠ℎ𝑎𝑓𝑡 = 25−0.02−0.004𝑚𝑚
Determine tolerance on shaft.
Question 4
Which of the following is not true for autocollimator?
Question 5
A sine bar is specified by
Question 6
CLA value and RMS values are used for the measurement of
Question 7
According to Indian Standard specifications 50H7g6.means that:
1). Actual size is 50 mm
2). Tolerance grade for hole is 7
3). Tolerance grade for shaft is 6
Which of the statements made above are correct?
Question 8
What does ‘50’ represents in 50H8/g7?
Question 9
A metric thread of pitch 2 mm and thread angle 60 ° is inspected for its pitch diameter using the 3-wire method. The indicated diameter of the wire will be nearly
Question 10
How is the tyre of a railway wheel fitted?
- 62 attempts
- 0 upvotes
- 3 comments
May 1AE & JE Exams
